← A-Level Chemistry · CCEA · A-Level Chemistry revision
⭐ 0
CCEA GCE Chemistry · Unit A2 1 / 4.7 Aldehydes and ketones
Mini-Lesson

Aldehydes and ketones

2 missions. Guess, learn, then check. Your place is saved.

  1. Mission 1Why does cyanide add across a carbonyl double bond but leave an alkene double bond alone?
  2. Mission 2Aldehydes and ketones look alike. Why does only one of them turn a test tube into a mirror?
Mission 1

Mission 1: Why does cyanide add across a carbonyl double bond but leave an alkene double bond alone?

Make a guess: Why does cyanide add across a carbonyl double bond but leave an alkene double bond alone?

Mission 1

The carbonyl group

Aldehyde and ketonealdehydeOCH3H120°ethanalketoneOCH3CH3120°propanone
  • Carbonyl: C=O.
  • Aldehyde: C=O at the end of the chain, with an H on it. R–CHO. Name ends -al: ethanal, CH3CHO.
  • Ketone: C=O inside the chain. R–CO–R′. Name ends -one: propanone, CH3COCH3.
  • The C=O carbon is trigonal planar (bond angles about 120°).
  • Branched example: 3-methylbutanal, (CH3)2CHCH2CHO; chains up to six carbons.
Mission 1

Boiling points and solubility

Forces between carbonyl moleculesbetween propanone moleculesOOδ+δ−δ+δ−dipole–dipolepropanone and waterOOHHδ+δ−hydrogenbondboiling point / °Cbutane−1propanal48propanone56propan-1-ol97Londondipole–dipoleH-bond
  • C=O is polar, so molecules attract by permanent dipole–dipole forces.
  • No H on O, so no hydrogen bonds between carbonyl molecules.
  • Boiling points (Mr about 58–60): butane −1 °C · propanal 48 °C · propanone 56 °C · propan-1-ol 97 °C.
  • The O lone pairs accept hydrogen bonds from water: small aldehydes and ketones dissolve.
  • Solubility falls as the hydrocarbon chain grows.
Mission 1

Why nucleophiles choose C=O

C=O or C=CC=O: polarORRδ+δ−NuNu− is attractedC=C: electron-richHHHHENuNu− is repelled
  • O is more electronegative: Cδ+=Oδ−.
  • A nucleophile (lone-pair donor) is attracted to the δ+ carbon.
  • Alkene C=C: non-polar and electron-rich. It repels nucleophiles and attracts electrophiles.
  • So C=O undergoes nucleophilic addition: nucleophile to C, then H to O.
Mission 1

Reduction with LiAlH4

  • Lithal (lithium tetrahydridoaluminate(III), LiAlH4) in dry ether.
  • Dry: LiAlH4 reacts violently with water. Water or dilute acid is added only afterwards.
  • Aldehyde → primary alcohol: CH3CHO + 2[H] → CH3CH2OH
  • Ketone → secondary alcohol: CH3COCH3 + 2[H] → CH3CH(OH)CH3
  • [H] stands for the reducing agent.
  • The nucleophile is the hydride ion, H⁻.
Quick check
?Butanone, CH3COCH2CH3, is reduced.
What is the organic product?
  • Reagent: LiAlH4 in dry ether, then dilute acid.
Mission 1

Adding cyanide: hydroxynitriles

  • Ethanal + HCN → 2-hydroxypropanenitrile, CH3CH(OH)CN
  • Propanone + HCN → 2-hydroxy-2-methylpropanenitrile, (CH3)2C(OH)CN
  • The chain gains one carbon.
  • Reagent: HCN, with KCN to supply CN⁻.
  • HCN is a weak acid: little CN⁻ on its own. The cyanide salt supplies the CN⁻ nucleophile.
Mission 1

Mechanism: cyanide

Mechanism: cyanide adds to propanoneStep 1Oδ+δ−CN12ONpropanone + cyanide ionalkoxide ionStep 2ONHCNδ+34with HCNOHN+CN2-hydroxy-2-methyl-propanenitrile
  • Show Cδ+=Oδ− dipole.
  • Arrow 1: from the lone pair on the C of CN⁻ to the carbonyl C.
  • Arrow 2: from the C=O π bond to the O. An alkoxide intermediate, C–O⁻, forms.
  • Arrow 3: from a lone pair on O⁻ to the H of HCN; arrow 4: from the H–C bond of HCN to its C. CN⁻ is regenerated.
Quick check
?In the mechanism for the reaction of propanone with cyanide, where does the first curly arrow start and end?
Mission 1

Why a racemic mixture forms

Why a racemic mixture formsplanarOCH3HCNCNabovebelow50 %50 %H3CCNHOHCH3NCOHHmirror images
  • The C=O group is planar.
  • CN⁻ attacks from above or below with equal probability.
  • If the carbon ends up with four different groups, it is a chiral centre.
  • So the product is a 50:50 mixture of enantiomers: a racemic mixture.
  • It does not rotate plane-polarised light.
  • Aldehydes (except methanal) and unsymmetrical ketones give racemates. Propanone does not: two CH3 groups.
Quick check
?Which carbonyl compound gives a racemic mixture when it reacts with HCN?
Mission check

?Hex-5-en-2-one, CH2=CHCH2CH2COCH3, has a C=C bond and a C=O bond.
What is the organic product?
  • It is treated with LiAlH4 in dry ether, then dilute acid.
Mission 2

Mission 2: Aldehydes and ketones look alike. Why does only one of them turn a test tube into a mirror?

Make a guess: Aldehydes and ketones look alike. Why does only one of them turn a test tube into a mirror?

Mission 2

Why aldehydes are easy to oxidise

Why aldehydes oxidise and ketones do notaldehydeOH[O]OOHpropanalpropanoic acidC–H → C–OHketoneOno C–H to replace:a C–C bond wouldhave to breakpropanone
  • Aldehyde: an H on the carbonyl carbon. Ketone: two carbons on it.
  • Mild oxidising agents turn that C–H into C–OH: aldehyde → carboxylic acid.
  • RCHO + [O] → RCOOH
  • Ketones would need a C–C bond broken: mild oxidising agents cannot do it.
  • The oxidising agent is reduced, and changes colour. That is the test.
Mission 2

Tollens' reagent: the silver mirror

Tollens' testhot waterpropanalpropanonesilver mirrorno changeAg+ + e− → Ag
  • Tollens' reagent: think of it as Ag⁺.
  • Make it fresh: AgNO3(aq) + a drop of NaOH(aq) → brown precipitate; add dilute NH3(aq) until it just dissolves. This gives [Ag(NH3)2]⁺.
  • Warm in a water bath, not over a flame.
  • Aldehyde: silver mirror (or grey-black precipitate). Ketone: no change.
  • Ag⁺ + e⁻ → Ag: silver ions are reduced; the aldehyde is oxidised.
  • Pour away straight after use: stored reagent can form explosive solids.
Mission 2

Fehling's and Benedict's solutions

  • Think of Fehling's solution as Cu²⁺.
  • Blue solution of a copper(II) complex, in alkali.
  • Warm with an aldehyde: brick-red precipitate of copper(I) oxide, Cu2O.
  • Cu²⁺ + e⁻ → Cu⁺
  • Ketone: stays blue.
  • Aromatic aldehydes such as benzaldehyde give little or no change with Fehling's: use Tollens'.
Mission 2

Acidified dichromate

  • K2Cr2O7 with dilute H2SO4, warm.
  • Aldehyde: orange → green (Cr2O7²⁻ reduced to Cr³⁺).
  • Ketone: stays orange.
  • Primary and secondary alcohols also turn it green, so it is not a test for aldehydes alone.
Quick check
?Propanal is warmed with Tollens' reagent and a silver mirror forms. Which statement is correct?
Mission 2

2,4-DNPH: is there a C=O?

2,4-DNPH testeach tube + 2,4-DNPHpropanoneorangeprecipitatepropanalorangeprecipitateethanoicacidnoprecipitateethylethanoatenoprecipitateprecipitate from propanoneNO2NO2NHN2,4-dinitrophenylhydrazone
  • 2,4-dinitrophenylhydrazine (2,4-DNPH). Also called Brady's reagent.
  • Add a few drops of the compound: yellow / orange precipitate with aldehydes and ketones.
  • No precipitate with the C=O of carboxylic acids or esters.
  • The product is a 2,4-dinitrophenylhydrazone; water is lost:
  • (CH3)2C=O + H2NNHC6H3(NO2)2 → (CH3)2C=NNHC6H3(NO2)2 + H2O
  • It tells you C=O is present, not which kind.
Mission 2

Which carbonyl? Melting point of the derivative

Recrystallisation and melting point1minimumhot solvent2coolcrystals form3filter, wash withcold solvent4dry, thenmelting pointto pump°C
  • 1. Filter off the precipitate.
  • 2. Recrystallise: dissolve in the minimum hot solvent (e.g. ethanol), cool, filter, wash with a little cold solvent, dry.
  • 3. Measure the melting point.
  • 4. Compare with a data table of derivative melting points.
  • Impurities lower the melting point and make it melt over a wider range.
Quick check
?A compound gives an orange precipitate with 2,4-DNPH. After recrystallising, the derivative melts at 154–156 °C. The compound gives no silver mirror with Tollens' reagent. Melting points of 2,4-DNPH derivatives: propanal 155 °C · propanone 126 °C · butanal 123 °C · pentan-3-one 156 °C. What is the compound?
Mission 2

Planning a test sequence

Test sequence flow chart2,4-DNPHorange precipitate: aldehyde or ketoneno precipitate: neitherTollens' or Fehling'smirror or brick-red: aldehydeno change: ketoneor acidified dichromate: orange → green= aldehyde (if no alcohol present)melting point of the derivativematch a data table: which compound
  • Step 1: 2,4-DNPH. Precipitate → aldehyde or ketone.
  • Step 2: Tollens' or Fehling's. Positive → aldehyde; no change → ketone.
  • Or warm acidified dichromate: green → aldehyde (if no alcohol is present).
  • Step 3: melting point of the 2,4-DNPH derivative → which compound.
  • One test rarely identifies a compound. Each test narrows the list.
Quick check
?Propanal and propanone are each warmed with Fehling's solution. What is seen?
Mission check

?4-Oxopentanal, CH3COCH2CH2CHO, has an aldehyde group and a ketone group. It is warmed with Tollens' reagent. What happens?
Recap

The big ideas

Mission 1

  • C=O is polar: nucleophiles add to the δ+ carbon, then the O gains H. C=C is not polar: no nucleophilic addition.
  • Attack from either face of the planar C=O gives a racemic mixture when a chiral centre forms.

Mission 2

  • Aldehydes (H on the C=O carbon) are oxidised to carboxylic acids; ketones are not. The reagent is reduced and changes colour.
  • 2,4-DNPH shows a C=O is present; the derivative's melting point identifies the compound.
🏆

Mini-lesson complete!

⭐⭐⭐

You've worked through Aldehydes and ketones for CCEA A-level Chemistry. 🎉

  1. Mission 1Why does cyanide add across a carbonyl double bond but leave an alkene double bond alone?
  2. Mission 2Aldehydes and ketones look alike. Why does only one of them turn a test tube into a mirror?

Your stars: 0 / 0

📣 Smashed it? Share your score

Challenge a friend to beat your stars, or show a parent how you got on.

→ Back to A-Level Chemistry · CCEA